AI-ROAD3D



The performance is not adequate, what else can I configure?

WARNING: Please read the disclaimer to make sure that all of the installation constraints have been fulfilled!

Go back


Installation Constraints

To ensure proper functioning of AI-INCIDENT the camera should be positioned so that it creates an 30° angle with the street. AI-ROAD3D

Moreover, the camera should frame the back of vehicles, so to avoid problems due to car headlights; it is also advisable to use an outdoor varifocal camera. Cameras should be installed on a pole or any other steady element, otherwise camera's vibrations could negatively affect the performance. Minimum height required is 5 meters (it is crucial to avoid occlusions between vehicles and that the whole vehicle is framed in the image and not just a part of it.), with a tilt angle of 15°. Lastly, please remember that to properly detect vehicles the minimum pixel area required is 50x50; any eventual zoom has to be configurated according to this requirement. AI-ROAD3D

Go back


Traffic monitoring sensor configuration

Monitoraggio Traffico

In the drop-down list on the left side, by selecting "Algorithm Parameters" and then “Traffic Monitoring” you can draw an area of interest directly on the live image on the left. The area of interest is a polygon with four vertices, with a line that shows the direction of travel.
Here some informations on how to set configuration parameters of this sensor:

  1. Sensor ID: identification of main sensor (only accepts whole numbers and it is not necessary to edit the default setting)
  2. Sensor Name: unique name of the associated sensor and used in events generation

In this panel you can also enable the following options:

  • Enable counting and classification of vehicles: enabled by default, counts and classifies vehicles and collects data on the average speed and colour of each vehichle.
  • Enable speed limit control: sends a notification when a vehicle travels at a speed above the limit (in km/h), specified during the configuration.
  • Enable traffic density control: sends a periodic notification (the period is specified during the configuration) along with information on traffic density. Go back